Eden Navigator WP-100 Specifications download pdf (Page 4)

Enhance Bypass

This switch allows the Enhance control to be turned on and off by panel or

foot switch. It's a great feature for doing a quick tone change while playing.

As with the other controls the panel switch overrides or takes control from

the foot switch. The red LED will be on when the switch is depressed. The

Bypass is engaged when the red LED is on.

Set Signal Level / Head room indicator

This is the LED located between the Gain and Enhance Controls. To achieve

best overall signal to noise ratio and maintain maximum Head room

dynamics you will want to adjust your gain so that the indicator just lights

on the louder notes. This indicator is fed from all the front end stages of the

unit including the tone controls and the side chain return. If any stage gets

close to overload it will flag the LED and alert you to take corrective action

by adjusting the gain chain. The unit is capable of (+ 21 dBm ) output on all

busses.

Tuner / Mute

The Mute to tune feature is addressable from both the front panel and the

foot switch. (NOTE) the panel switch has priority over the Foot switch

control on all features. This feature mutes all the output busses including the

D.I. buss and the Main outputs. It is silent going to mute and has a slow

ramp up during the return to normal operating position. The Tuner buss stays

live during the Mute operation allowing the tuner to remain plugged in to the

Tuner output jack at all times. The Mute is engage by depressing the Mute

switch. The green LED comes on to remind you that the Mute is engaged.

Compressor Bypass Switch

This allows for the Compressor to be switched in and out by both the panel

switch and the foot switch. Remember that the panel control has priority

over the foot switch. The Bypass is engaged and the red LED goes on when

the switch is depressed. The Compressor is then in the bypass mode.

1 2 3 4 5 6 7 8 9 ... 13 14

No comments

Eden Navigator WP-100 Specifications Page 4