Eden World Tour WTX1000N Specifications

THE LEADER IN BASS AMPLIFICATIONWorld TourBass Guitar AmplifierCovering ModelWTX1000N Powered NavigatorNever Compromise©04-16-2009 by U.S. Music Corp

10Tuner Out Jack  This standard 1/4-inch jack is designed to provide a pre-gain signal for connection to a tuner. It can also be used to provide pre-

11INITIAL SET UPBefore turning your WTX1000N ON, you must first determine which mode ofoperation you wish to use. It is critical to the safety of your

12Once youve established that your unit is set to the correct voltage, set theMaster Volume control to minimum (fully counter-clockwise). Set the ton

13The ratio is variable from very soft compression (fully counter-clockwise) tohard limiting (fully clockwise). The Compressor light will blink when y

14Slowly bring the Enhance control up while playing. If you turn it up close to12:00 on the dial and still dont have your sound, stop there. Return t

15Now, cut the Level control to approximately 3:00 and do the same thing.Repeat this process with the two remaining control sets. By the way, thisproc

16Frequency enhancement results from cabinet placement and room acoustics.A cabinet placed on the floor will have the lower frequencies boosted byabou

17MAINTENANCEYour Eden amplifier has been designed to require minimal routinemaintenance. Attention to the following areas will ensure optimumperforma

18

2Bass Guitar AmplifierWTX1000N Powered NavigatorOPERATION MANUALPublishing Date 04-16-2009FOREWORDCongratulations on the purchase of your new Eden Wor

3Please read this manual in its entirety before operating your new amplifier.Failure to do so could result in misuse or damage. Weve taken the time t

4FRONT PANEL FEATURESInput Jack  Designed to accept a standard 1/4-inch mono phone plug. Forbest results use a high quality shielded cable to connect

5Enhance Bypass Switch  disengages the Enhance control for a quickchange in tone. The indicator to the left of this control will be lit when theEnhan

6Mode Selector Switch  Your WTX1000N can be operated in Stereo orBi-amp mode. This switch allows you to choose which mode is used.Limit Switch  This

7IMPORTANT NOTE: DO NOT use this jack for a Mono Signal Send!It may be possible to damage the mono headphones inserted into thisjack, as well as your

Combination Power Cord Jack and Fuse Holder  The removable powercord is attached here. To access the fuse holder, pull the holder out of the topof th

9Main D.I. Outputs  These fully balanced stereo XLR outputs provide+16dBm maximum. They can be used to send a stereo signal to a mixingboard or recor