Eden WTX500 User Manual download pdf (Page 9)

NEVER COMPROMISE

| 9

EDEN

| METROMIX SERIES |

WTX500 - 7

WTX500 Front Panel Navigation:

1. Illuminated Eden logo; Illuminates when unit is switched on.

2. Input; connect your instrument to the amplifier.

3. Tuner Mute Indicator; illuminates when tuner mute is active.

4. Gain Control/Input Pad; Adjust the amount of input signal to

the amplifier here/Pull this control to engage a -12bB pad for

higher output instruments.

5. Tuner Mute Switch; Press to toggle tuner mute on/off.

6. Level Indicator; Use this to help set your input signal level this

should illuminate on your loudest/lowest notes.

7. Enhance Control; Providing Eden tone shaping use this control

to increase the amount of proprietary EQ sweep in your sound /

pull this control to bypass the amplifiers internal compressor.

8. Effects Loop Send; Signal Out.

9. Bass Level Control; Use this control to select the amount of

cut or boost you require in the low frequency range / Pull control

to engage Bass Boost function to achieved added low end.

10. Effects Loop Send; Signal In.

11. Mid Level Control; Use this control to select the amount of

cut or boost you require in the mid frequency range / pull

control to move where in the mid frequency range mid cut or

boost is applied.

12. Auxiliary Input Left.

13. Treble Level Control; use this control to select the amount of

cut or boost you require in the Higher frequency / Pull this

control to move the DI signal to post position in the amplifier.

14. Auxiliary Input Right.

15. Limit Indicator; Displays when amplifier power output is

being reached.

16. Master Control; Adjust the overall output level of the unit.

17. Tuner Out; Connect your rack or foot pedal tuner.

WTX500 Rear Panel Navigation:

1. Power Inlet; Insert supplied power cord.

2. Power Switch; Turn your amplifier off and on.

3. Footswitch; Connect optional footswitch here to toggle tuner

mute and enhance functions.

4. Recording DI Out; Take your DI line for a recording console or

desk from.

5. Ground Lift Switch; Switch ground lift feature for the XLR

Recording DI output.

6. DI Level Control; Adjust the output level of the DI.

7. Headphone Out; Connect your headphones to the amplifier.

8. ¼ Jack Output 1; Connect your amplifier to a speaker cabinet.

9. Speakon Output 1; Connect your amplifier to a speaker cabinet.

Always ensure that that the total load for your amplifier does not fall

below the recommended 4 ohm impedance for this amplifier as it can

cause the protection circuit to engage and in some cases may damage

the amplifier.

WTX500 Quick Start Guide

The WTX500 provides the ability to easily take Eden tone and power with you in a compact portable package. Not only can you get great

tone and power out of this punchy little amplier, but you also have access to an effects loop, auxiliary inputs and a exible DI on the rear

of the amplier. With its 500W power output the WTX500 can deliver a surprising amount of volume.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Comments to this Manuals

No comments

Eden WTX500 User Manual Page 9

Comments to this Manuals

Related products and manuals for Audio Eden WTX500