Eden Nemesis Silver Series NA80 User Manual download pdf (Page 4)

Please take the time to review this manual and to send in your

warranty registration card.

GENERAL FEATURES

Your Nemesis Silver Series Combo has all the following features: a 90

to 130 watt FET power amplifier @ 8 Ohms, dual channels, heavy duty

passive thermal cooling, extension speaker compatibility, automatic

thermal protection circuit, compressor/limiter with in/out switch, aux

channel with tone and level controls, enhance control, 3-band tone

control, speaker on/off switch, headphones jack, aux speaker output, full

D.I. with ground lift switch and level control, effects loop, all plywood

enclosure, and powerful, great sounding Eden designed loudspeakers.

SET UP AND GETTING STARTED

Before turning on your Nemesis Combo, you need to do a few things

first. If your unit was shipped directly to you from a dealer, check

carefully for hidden freight damage before you attempt to operate the

unit. If you find any damage, notify your dealer and the freight line

immediately. If you picked up your unit from your dealer, it was probably

set up and tested out already. To be safe, we suggest that you go

through the set up now.

INITIAL SET UP

Before you plug in your unit for the first time, please do the following

things. First, turn the power switch to the off position. Check the back of

your unit for the correct voltage notation for your country of operation.

Once you’ve ensured correct voltage, set the master volume control to

minimum (0). Set the tone controls to the center position (12:00 or 0).

Turn the enhance control to the minimum position. Set the gain control

to approximately the 10:00 position. Set the compressor in the on

position. On the front of the unit, set the internal speaker switch in the on

1 2 3 4 5 6 7 8 9 10 11

No comments

Eden Nemesis Silver Series NA80 User Manual Page 4