Eden WT800B User Manual download pdf (Page 12)

Make sure the Bi-amp switch is OFF, or flush with the panel.

Set the Balance control to the 12:00 position.

Bi-Amp Operation:

Connect the appropriate speakers to each individual amplifier Output.

Engage the Bi-Amp Operation switch. When ON, the switch will stick out

slightly from the face of the amplifier.

Make sure the Bridge Mono switch is OFF, or flush with the panel.

Use the Crossover control to determine which frequencies will go to the

speakers. Because bass frequencies require far more power to reproduce the

treble frequencies, we suggest that you start out low (or left) on the dial. But

it’s only a suggestion. We gave you a crossover control so you could make

your own decision. (You’re welcome!)

If necessary, us the Balance control to balance the volume between the low

and high speakers.

IMPORTANT NOTES: Never, and we mean NEVER, attempt to do

any of the following:

• Use Bi-Amp and Bridge Mono modes at the same time.

• Use Inappropriate Outputs to connect speakers.

• Switch modes of operation while the amplifier is on.

• Connect both individual amplifier outputs to the same speaker.

(That’s what Bridge Mono is for.)

Failure to follow these precautions can cause significant damage to your

amplifier &/or speakers. We’re serious about this. Pay attention.

GETTING A GREAT TONE

As bassists, each of us has in our head a concept of our perfect sound. Eden

amplifiers are designed to help you easily achieve the sound you hear inside

you. However, it’s a multi-step process as explained below.

1 ... 11 12 13 ... 21

No comments

Eden WT800B User Manual Page 12