Eden WT800B User Manual download pdf (Page 6)

EQ Clip Light – indicates clipping in the EQ section. Clipping is a Very

Bad Thing and should be avoided at all times. We’ll tell you how to avoid

this later in the manual.

Compressor Defeat Switch – To defeat the Auto-Compression circuit,

depress this switch.

Compressor Indicator Light – Indicates compression is taking place.

Master Level Control – Adjusts overall system output and stage loudness.

Bi-Amp Switch – Engages Bi-Amp Mode. This mode is ON when the

switch is UP (sticking out from the face plate slightly).

EXTREMELY IMPORTANT NOTE: Do NOT engage bi-amp

operation in combination with Mono Bridge. Doing so may cause

damage to your amplifier and possibly your speakers! Also, it will sound

REALLY BAD!

Balance Control – Balances power between the two amplifiers: High (or

Left) and Low (or Right). This is useful when using cabinets of different

impedance &/or efficiency.

Crossover – Determines the crossover point between amplifiers when in Bi-

Amp Mode. In all other modes of operation, this feature is defeated.

Mono Bridge Switch – Engages Bridge Mono Operation. To engage, push

the switch IN.

Mono Bridge Indicator – Lights to show that the amp is in Bridge Mono

mode.

EXTREMELY IMPORTANT NOTE: Do NOT engage Mono Bridge in

combination with bi-amp operation. Doing so may cause damage to

your amplifier and possibly your speakers! And, as we said earlier, it

will sound REALLY BAD.

Headphone Jack – Accepts a standard _ inch stereo or mono headphone

plug. It can also be used as a Master Output send to slave another amplifier.

1 2 3 4 5 6 7 ... 21

No comments

Eden WT800B User Manual Page 6