Eden WT800B User Manual download pdf (Page 8)

Bridge Mono Output – This is a single NL-4 connector to be used ONLY

in Bridge Mono operation. . The total speaker load impedance should not go

below 4 ohms.

Combination Power Cord Jack and Fuse Holder – The removable power

cord is attached here. To access the fuse holder, pull the holder out of the top

of the power receptacle. Your unit was shipped with a spare fuse inserted in

the fuse carrier. USE ONLY THE SAME SIZE AND TYPE FOR

REPLACMENT. Using a fuse with a different rating than specified is a

VERY BAD THING and can cause damage to your amplifier. All

models come with a holder marked (FUSE) or (115/230) and are factory

configured for 100/120/ 230/240 only and must be adapted by a service tech

for any voltage change.

Fuse Requirements:

USA @ 120 Volts /60 HZ – 10 Amps, 5 x 20 mm GMC/T/slow blow

Europe @ 240 Volts/50 Hz - 5 Amps, 5 x 20 mm GMC/T/slow blow

Japan @ 100 Volts/60 Hz - 12 Amps, 5 x 20 mm GMC/T/slow blow

IMPORTANT NOTE: Always use slow blow or time delay type fuses.

Do not use fast blow fuses.

To convert your amplifier from US to European fusing, remove the Fuse

Holder and insert a 5 Amp slow blow fuse. Flip the fuse holder over and

reinsert.

IMPORTANT NOTE: In order to operate properly in other parts of the

world, your amplifier may require minor modifications. These

modifications must be made by a QUALIFIED technician. Contact your

local distirubtor for further information.

Recording Out (D.I.) – This fully balanced XLR output allows you to send

a pre- or post-EQ signal to a recording or sound reinforcement mixing

console. We use Pin 2 hot configuration. Adjusting the Master Volume

control will not affect this send. This output is designed to use with phantom

powered systems. However, it never hurts to turn off the phantom power at

the board, if possible.

1 2 3 4 5 6 7 8 9 ... 21

No comments

Eden WT800B User Manual Page 8